User manual

Quick Start 4-3

Step 4: Put the BridgeWay in Idle Mode

The BridgeWay powers up in Idle mode, and is controlled by the Ethernet scanner

through the output command register. Make sure that the module is in Idle mode

by verifying that the BridgeWay Status LED is flashing green (the LED is solid

green when the module is in Run mode). If the module is not in Idle mode, place

the connected Ethernet scanner in Idle or Program mode.

Step 5: Set the DeviceNet MAC ID and Baud Rate

• Select the Tools menu option and pull down menu.

• Select the Node Commissioning option. Another screen appears.

• Click on Browse and choose the DeviceNet network.

• When the browse is completed, double click on the BridgeWay icon.

• Enter the desired MAC address and/or baud rate, then click the Apply but-

ton.

Note: The BridgeWay will automatically reset if a new MAC ID is entered. If

only the baud rate is changed the BridgeWay must be power cycled before the

new baud rate will take effect.

Note: When the MAC ID is changed, the BridgeWay’s I/O configuration is

cleared.