User manual

Configuration 3-12
© 2011 Pyramid Solutions Inc. Publication PUB-AB7603-014
Setting the IP Address Using the Web Page
The ethernet addresses can also be configured using the Status and Settings web
page resident on the BridgeWay. The Status and Settings web page appears as
shown below.
The IP address, subnet mask, gateway and mail server addresses are displayed in
the edit boxes on the web page. Changing any values and clicking the Submit Val-
ues button will set the addresses in the BridgeWay. Note that a power cycle or
module reset is required for the changes to take effect.
The Reset Module button can be used to reset the BridgeWay from the web
browser. A status of “RESETTING...” will display while the module resets and
comes back online. The web page will be refreshed after the module has booted.
Figure 3-3 Status and Settings Web Page