User manual

Installation 2-4

Connecting DeviceNet

The DeviceNet network connection is a 5-pin terminal block located next to the

power connection on the end of the module. The female terminal block connector

is provided with the BridgeWay. Connections to be made are illustrated in Figure

2-3.

A 120 ohm termination resistor (not provided) may be required for proper net-

work termination. See the DeviceNet Specification for specific rules on

DeviceNet connections and termination.

For information on setting the DeviceNet network configuration (MAC ID, baud

rate, etc.), see “DeviceNet Network Configuration” on page 3-15.

Connecting to Ethernet

The Ethernet connection uses a standard RJ45 connector (not provided). This is

plugged into the socket on the end of the module.

For information on setting the Ethernet IP configuration (IP address, DHCP, etc.),

see “Ethernet Network Configuration” on page 3-6.

Figure 2-3 DeviceNet Connection

(Red) Net Power 24VDC +

(Black) Net Power 24VDC Common

(White) CAN High

(Blue) CAN Low

CAN Shield