User manual

Status and Diagnostics 10-8
© 2011 Pyramid Solutions Inc. Publication PUB-AB7603-014
84 Slave connection initialization in progress.
The I/O connection establishment sequence to this slave is in
progress.
85 Incorrect data size received on connection.
The amount of data received with the last connected message
does not match the connection size.
86 Device went into Idle mode.
The slave is in Idle mode as indicated by the slave sending
idle packets on the input connection. Idle packets are of zero
length and are used to keep the connection open, yet not move
any data when the device is in Idle mode.
87 Shared master error.
The slave scanlist entry is configured for input sharing and the
primary master has not made connection to the device.
88 Shared master choice error.
The slave scanlist entry is configured for input sharing and the
primary master has not made the right type of connections to
the device.
89 ADR error.
An error occurred during auto device replacement or auto con-
figuration. This is triggered when the slave returns an error
response during an auto device replacement or auto configura-
tion message sequence.
90 CAN network disabled.
The CAN network has been disabled. The network is disabled
by setting the Disable bit in the output command register.
This status is only used for the local MAC ID.
91 CAN bus-off.
Indicates that the CAN controller is in the Bus-Off state.
This status is only used for the local MAC ID.
Status Code Description
Table 10-6 Node Status Codes (Continued)