User manual

Status and Diagnostics 10-7

76 No messages for scanner.

No CAN packets specifically for the DeviceNet scanner have

been received in more than 10 seconds.

This status is only used for the local MAC ID.

77 Incorrect connection size.

The connection size configured in the scanlist entry for the

slave does not match the actual required connection size spec-

ified by the slave.

78 No device response.

A connection could not be established with the slave because

it did not respond.

79 CAN DUP-MAC transmit failure.

The scanner was unable to transmit the duplicate MAC detec-

tion message on the CAN network.

This status is only used for the local MAC ID.

80 In Idle mode.

The device is in Idle mode.

This status is only used for the local MAC ID.

81 In Fault mode.

The device is in Fault mode. Fault mode is set using the Fault

bit in the output command register. i.e. Fault mode is con-

trolled by the EtherNet/IP or Modbus/TCP master controller.

It can be used to indicate a system fault detected at a higher

level. When the device is in Fault mode, all DeviceNet net-

work activity is disabled.

This status is only used for the local MAC ID.

83 Error during slave connection initialization.

An error occurred while creating the I/O connections to the

slave (beyond the identity mismatch or I/O size errors). This

error is triggered by error responses from the slave during the

connection establishment sequence.

Status Code Description

Table 10-6 Node Status Codes (Continued)