User manual

Module Description 1-3

DeviceNet Features

• DeviceNet Master scanner functionality supporting up to 63 DeviceNet

slave devices

• Explicit Messaging and Bit Strobe, Poll, Change of State (COS), and

Cyclic I/O connections.

• Baud rates of 125, 250, and 500 Kbps.

• Automatic baud rate detection option may be enabled or disabled.

• Automatic Address Recovery can be configured to replace a faulted slave

device with a replacement device at the same MAC ID.

• Configuration Recovery can be configured for slave devices so that a

newly replaced slave can be configured to the same settings of the device

it replaces. Combined with Automatic Address Recovery this feature is

known as Automatic Device Recovery (ADR).

• Transfers 496 bytes DeviceNet slave input data and 492 bytes DeviceNet

slave output data.

• DeviceNet Quick Connect.

• Active Node List monitoring tracks the online status of all DeviceNet

nodes. Bridged CIP messages will be immediately rejected if the target

node is not online.

• Configurable input safe state mode determines the state of slave input

data when a slave’s I/O connection times out.

Ethernet Features

• Supports the EtherNet/IP protocol, Adapter Class with I/O Server, Mes-

sage Server, and CIP Message Routing.

• Supports the Modbus/TCP protocol with up to 8 simultaneous connec-

tions. Conforms to the Modbus/TCP specification 1.0.

• Features UDP and TCP/IP protocol stack.

• Address may be set via DHCP/Bootp, DIP switch, or software configura-

tion