User manual

Configuration 3-2

DIP Switch Example

The switches are set to 00010100 (20 decimal) (The switch position is shown in

White in the diagram.)

The IP address of the module will be set to 192.168.1.20.

Note: The numbers on the switches on the IP configuration DIP switch do NOT

correspond to bit locations in the address value. In fact, they are reversed. i.e. bit 0

is set by switch 8.

Setting the IP Address Using DHCP/BootP

When DHCP/BootP is enabled and a DHCP or BootP server is found, the IP

address, Subnet mask, and Gateway address is automatically configured by the

DHCP/BootP server. It can be enabled using the BridgeWay’s Settings web page.

Note: The use of DHCP is the default configuration for the BridgeWay as

shipped.

Figure 3-1 IP Configuration DIP Switch