Owner manual

SFM62SS

SFM62SS: 2005-10 GT 409 Stainless Axle-back Mufer Delete, 4” tip.

Thanks again for purchasing your new stainless steel Pypes Performance

Exhaust 05-10 Ford Mustang Axle-back system. Please be sure to conrm

all the components in the kit were received in your shipment before begin-

ning installation. These kits include your new Axle-Back Mufer Delete

System w/ 4” polished stainless rolled edge tips and a four band clamps. If

you nd any components missing, please contact our ofce at 800-421-3890

for replacement. Installation of these kits will require a few simple tools: jack

stands, 13mm & 15mm wrenches and penetrating oil. For a quicker and

tighter installation, air tools are recommended. Technical assistance is avail-

able both online at www.pypesexhaust.com or 800-421-3890.

Pypes Performance Exhaust

2705 Clemens Road Bldg 105A Hateld, PA 19440

800-421-3890 (voice) 267-638-3507 (fax)

www.pypesexhaust.com

(A) MuferDelete

 Tailpipes

(A)

1. Begin by placing the vehicle on a lift or four jack stands at maximum height. This will aid in an easier installation.

2. Unbolt the factory band clamps (15mm wrench) connecting your factory axle-back to your mid-pipes. Soaking your factory

mounting points with penetrating oil will allow for easier removal. Next, remove all the bolts (13 mm wrench) connecting the factory

hangers to the frame rails. Now, drop both sides out from under the car.

3. It’s time to install your new axle-back mufer delete system. Begin by installing the two band clamps on to the axle-back muf

er necks. Place the factory hanger in the right conguration on to the welded wire forms on the axle-backs. Slide the expanded necks

on to the mid-pipes, and then bolt the hangers back on to the frame rails. Once all the hanger bolts are tight slide the 4” tips on to the

end of the tailpipe with a band clamp, adjust to your liking and tighten. Be sure to check all the connection points periodically, as they

may come loose.

Note: If you nd the new tips are not aligned properly in the bumper cutouts, you may need to adjust your factory mid-pipes by

loosening the two band clamps located where your factory h-pipe meets the mid-pipes. A slight rotation of the mid pipes will allow for

the best t.

Nowit’stimetoreupthatmusclecarandenjoyyour

newPypesPerformanceExhaust.