Manual
1. Begin by placing the vehicle on a lift or four jack stands at maximum height. This will aid in an easier installation.
2. Unbolt the factory band clamps (15mm wrench) connecting your factory axle-back to your mid-pipes. Soaking your
factory mounting points with penetrating oil will allow for easier removal. Next, remove all the bolts (13 mm wrench) connect
-
ing the factory hangers to the frame rails. Now, drop both sides out from under the car.
3. It’stimetoinstallyournewaxle-backmuferdeletesystem.Beginbyinstallingthetwobandclampsontothemufer
necks.Placethefactoryhangerintherightcongurationontotheweldedwireformsontheaxle-backs.Slidetheexpanded
necks on to the mid-pipes, and then bolt the hangers back on to the frame rails. Once all the hanger bolts are tight make
sure the tip is adjusted properly in the bumper cut-out and now tighten the band clamps. Slide the 4” tips on to the end of the
tailpipe with a band clamp, adjust to your liking and tighten. Be sure to check all the connection points periodically, as they
may come loose.
Note:Ifyoundthenewtipsarenotalignedproperlyinthebumpercutouts,youmayneedtoadjustyourfactorymid-
pipes by loosening the two band clamps located where your factory h-pipe meets the mid-pipes. A slight rotation of the mid
pipeswillallowforthebestt.Mostyears,theroundalignmenttabattherearofyourmidpipeswillneedtobegroundoffto
allow the axle-back delete pipe to slide on far enough for proper tip alignment.
Nowit’stimetoreupthatmusclecarandenjoyyour
new Pypes Performance Exhaust.
SFM60MS
SFM60MS: 2005-10 GT 304 Stainless Pype Bomb, 4” tip.
Thanks again for purchasing your new stainless steel Pypes Performance
Exhaust 05-10 Ford Mustang Axle-back system. Please be sure to conrm
all the components in the kit were received in your shipment before begin-
ning installation. These kits include your new PYPE BOMB System w/ 4”
polished stainless dual wall tips and a (2) band clamps. If you nd any com-
ponents missing, please contact our ofce at 800-421-3890 for replacement.
Installation of these kits will require a few simple tools: jack stands, 13mm
& 15mm wrenches and penetrating oil. For a quicker and tighter installation,
air tools are recommended. Technical assistance is available both online at
www.pypesexhaust.com or 800-421-3890.
Pypes Performance Exhaust
2705 Clemens Road Bldg 105A Hateld, PA 19440
800-421-3890 (voice) 267-638-3507 (fax)
www.pypesexhaust.com
(A) Pype-Bomb Tailpipes
(A)
(A)