Treasure Hunter Platinum Weatherproof Pro-Metal Detector with Integrated Circuitry Headphones PHMD4 www.pyleaudio.com OWNER'S INSTRUCTION MANUAL_____ The Treasure Hunter Platinum detector has all the professional circuitry built into the headphones. The metal detector is water resistant and weatherproof. It is a superior unit made to last for years of treasure seeking fun for the professional or beginner.
SPECIFICATIONS Operating Search Frequency: 2.4KHZ Search-coil: 7.8 inch Concentric, Waterproof Audio Frequency: 400HZ Operating Environments: Land, Seaside, River, Rain, Shallow Water Water Resistant: Detecting in rain and accidental submergence in water acceptable Length: Adjustable from: 39.4 inch to 47.3 inch Battery: a 9-volt Alkaline (not included) Battery Life: Up to 20 hours Low Battery Indicator: When the speaker sounds a long tone, it’s time to replace the battery.
2. Wind the search-coil cable around the stem. Use the nylon on the stem to fasten the cable.(see Figure 2) 3. Rotate the stem’s lock nut clockwise to loosen it. Stand and stretch your arm, holding your metal detector to make the search-coil hovers above the ground for about 1 inch. Rotate the stem’s lock nut counterclockwise to tighten it. 4. Loosen the knob at the search-coil’s end, and adjust the search-coil angle to the desired angle so that it is parallel with the ground. Then tighten the knob.
Place a 9V battery into the battery-compartment matching the polarity symbols(+ and -) that are marked inside and reinstall the battery cover. Then carefully align the ear-cup halves and press until a solid “snap” is heard. NOTES: If you don’t plan to use the unit for a week or more, please remove the battery. Please make sure use an alkaline batteries. With fresh alkaline batteries you can use unit for more than 20 hours.
The Discrimination(DISC) and Sensitivity(SENS) have “stay-put” segmented position adjustments. Segmented controls allow the operator to make adjustment without removing the headphones to view the position numbers. 1. VOLUME CONTROL(VOL) “VOL” regulates the loudness of target response. The volume control adjustment is continuous and not segmented. “VOL” has a power switch (ON-OFF).Through the “VOL” control, you can easily power on or power off your detector. 2.
2. Turn the headhunter pirate power on. Set volume to a desired level. This can be accomplished by passing a coin back and forth under the search-coil. 3. Rotate the “SENS” clockwise till some solid sounding audio is heard. 4. Then rotate it counterclockwise a little till the audio signal is disappeared. 5. Set the “DISC” to ALL METAL position, in case it will reject some metal targets you want. 6. Keep the search-coil be parallel with the ground,-and about 1/2 to 1 inch above the surface.
CARE AND MAINTENANCE Your metal detector is an example of our superior design and craftsmanship. The following suggestions will help you care for your metal detector so you can enjoy it for years. Handle the detector gently and carefully. Dropping it can damage circuit boards, cases, and can cause the detector to malfunction. Use the detector only in normal temperature environments. Extreme temperatures can shorten the life of electronic devices and/or damage the cases of the detector.
