User Manual

1. Open the battery cover and install a fresh 9V battery, observing the
correct polarity. And then close the cover.
2. Plug in either the clip-on or the headset microphone.
3. To use the clip-on MIC, attach it at chest level. Do not place too close
to the mouth - a distance of about six inches usually works best. To
use the headset MIC, place it on the head and adjust the MIC boom
so that the MIC is about one inch to the side of the front of the mouth.
(Note: The clip-on or headset MIC wire is also the transmitting
antenna. Rolling up or shortening the wire may reduce the effective
operating range. Extend the wire fully during use and keep it as
straight as possible.)
4. Turn on the transmitter by sliding the power switch to ON position.
Power indicator will give a single quick flash, indicating usable battery
strength. In the case of a dead or low battery, the power indicator
either will not go on at all or will stay on continuously, indicating that
the battery should be replaced with a fresh one.
5. The RF indicator on the amplifier should now be lit.
6. Adjust the volume control of body pack and/or volume control of the
amplifier to a comfortable listening level as desired.
7. If the transmitter is not going to be used for any length of time, push
power switch to OFF position and remove the battery.
-5- -2-
1. Echo control
2. Treble control
3. Bass control
4. Power/volume switch
5. MIC IN socket
6. DC IN socket
7. Power indicator
8. Battery charging indicator
9. Wireless receiver RF indicator
10. Wireless receiver antenna
11. MP3 LED display
12. MP3 mode
13. MP3 play/pause/repeat
14. MP3 previous/volume down
15. MP3 next/volume up
16. USB port
17. Microphone holder
18. Speaker
19. Keyboard in socket
20. Cassette in socket
21. REC out socket
22. Battery compartment for
6PCS UM-1 batteries
18
1 2 3 4 5 6 7 8 9
12
13
14
15
16
17
10
11
PARTS DESCRIPTION
19
20
21
22
1. If feedback (howling sound) occurs, try first turning down the treble
control. If feedback still is present, try turning down the volume or
repositioning this unit with respect to the wired or wireless microphone
being used.
2. Extend the antenna fully whenever using the wireless microphone to
ensure optimum performance and maximum range.
ATTENTION: