User Manual

TREBLE
BASS
ECHO
CHG
REC
OUT
MIC IN
W/MIC VOL
POWER
ON
OFF
MP3 VOL
DC 12V
系统功能图示
1. Power ON/OFF switch
2. MP3 volume control
3. Power ON LED indicator
4. RF ON LED indicator
5. External DC input jack
6. Wireless receiver antenna
7. Charge LED indicator
8. Echo level control
9. Bass level control
10. Treble level control
11. Record out jack
12. MIC Input jack
13. Wired/wireless MIC
volume control
14. MP3 display
15. MP3 mode
16. MP3 previous/volume-
17. MP3 next/volume+
18. MP3 play/pause
19. USB port
20. SD/MMC card slot
21. Speaker
22. AC input jack
23. Battery compartment
15
14
13
12
11
10
9
8
7 6
5
4
3
2
1
16
17
18
19
20
21
23
PARTS DESCRIPTION
-5-
-2-
22
1. Open the battery cover and install a fresh 9V battery, observing the
correct polarity. And then close the cover.
2. Plug in either the clip-on or the headset microphone.
3. To use the clip-on MIC, attach it at chest level. Do not place too close
to the mouth - a distance of about six inches usually works best. To
use the headset MIC, place it on the head and adjust the MIC boom
so that the MIC is about one inch to the side of the front of the
mouth.
Note: The clip-on or headset MIC wire is also the transmitting
antenna. Rolling up or shortening the wire may reduce the effective
operating range. Extend the wire fully during use and keep it as
straight as possible.
4. Turn on the transmitter by sliding the power switch to ON position.
Power indicator will give a single quick flash, indicating usable
battery strength. In the case of a dead or low battery, the power
indicator either will not go on at all or will stay on continuously,
indicating that the battery should be replaced with a fresh one.
5. The RF indicator on the amplifier should now be lit.
6. Adjust the volume control of body pack and/or volume control of the
amplifier to a comfortable listening level as desired.
7. If the transmitter is not going to be used for any length of time, push
power switch to OFF position and remove the battery.
OPERATION OF BELT PACK TRANSMITTER