PDWM4350U PDWM4360U PDWM4350U - PDWM4360U UHF Wireless Microphone System Kit
CATALOG 1. FOREWORD Please read the instructions carefully to ensure proper use and operation of the product. Also, keep the instructions for future reference. --------------------------------------------------------------------------------------------- 2. INTRODUCTION --------------------------------------------------------------------------------------- 3. SYSTEM FEATURES 4.
FOUR CHANNEL RECEIVER FEATURES 1. Power Button: Power ON/OFF the receiver. 2. Power Indicator: Indicate the power ON/OFF. 3. LCD Information Display: Show the receiver frequency channel ect. 4. Down Function Button: Sets channel data. 5. Up Function Button: Sets channel data. 6. "AF" Audio Level Indicator: Indicates the wireless system audio signal level. 7. "RF" Signal Indicator: It glows when the Receiver receive RF signal from Transmitter. 8. Antenna. 9.
BODY-PACK TRANSMITTER FEATURES TRANSMITTER BATTERY INSTALLATION 1. Battery Installation of Handheld Microphone: Open the battery cover. Insert the supplied batteries into battery jar in polarity and cover the battery. 1. Power and Audio Mute Switch. 2. Antenna: Transmit the RF signal of transmitter. 3. Belt Clip: Attach the transmitter to the belt. 4. Audio Input Jack: Suitable for lavalier system/headset system. 5.
BODYPACK TRANSMITTER CONNECTION SYSTEM CONNECTION 1. Lavalier Microphone Connection: Connect the connector of supplied 1. Receiver Power Connection: Connect the DC connector of supplied AC/DC adapter Into the DC power input of receiver. Plug the AC Input connecter into an AC120/60Hz or AC220V/50Hz outlet. (Shown as below) lavalier microphone to the connecting jack of transmitter (shown as below) Set the transmitter work state in wireless lavalier system (L). 2.
TROUBLESHOOTING PROBLEM No Sound SYSTEM SPECIFICATIONS INDICATOR STATUS SOLUTION Red transmitter Slide transmitter POWER ON/OFF switch to ON position. Make sure battery is indicator is not inserted properly, observing battery (+/-). flashing If the battery is inserted properly, replace with fresh battery.
HAND-HELD TRANSMITTER SPECIFICATIONS Power Requirements 1.5VAA battery X 2 Nominal Current Drain LESS THAN 100mA Modulation Type FM RF Output MORE THAN 10dBm Max Deviation ±70KHz Spurious Emission MORE THAN 55dB Dimensions 238MM X 50MM X 50MM BODY-PACK TRANSMITTER SPECIFICATIONS Power Requirements 1.
