User Manual

www.PyleUSA.com

PDWR30B

• Excellent for Use On Boats/ Marine/ Decks/ Patios/ Poolside/ Outdoors

• Completely Water Proof

• 3.5'' Aluminum Injection Cone Woofer

• 40 Oz. Magnet Structure

• 1'' High Compliance Myiar Tweeter

• Capacitor Crossover Network

• Bass Reex Vent for Added Bass Response

• Heavy Duty ASB Construction

• Quick Connect/ Disconnect Speaker Terminals

• Unique Spring Loaded Mounting System

• Removable Rustproof Mesh Grills

• Power: 150Watts RMS/ 300Watts Peak

• Frequency Response: 60-20K Hz

• Impedance: 4 Ohms

• Dimensions: 4.75''(W)x 7.25''(H) x 4.75''(D)

HOW TO INSTALL

MOUNTING THE BRACKET

4. DrIII pllot holes Into the mounting surface.

5. Gently pull the speaker wire though the wire hole in the center of the mounting bracket,

so that the holes all line up.

6. Use your hardware to attach the bracket to the mounting surface.

1. Remove the bracket knobs and the bracket from the speaker.

2. Hold the bracket up to the mounting surface. "PDWR30B

Waterproof Speakers" can be mounted either horizontally

or verticalIy, hold the bracket so that the speaker wire ts

through the large, circular wire hole in the bracket, align the

bracket to be square with the surrounding (Use A level for

accuracy)

3. Mark the locations of the three shaped screw holes, use all of

the holes.

MOUNTING

PAGE 1
PDWR30B • Excellent for Use On Boats/ Marine/ Decks/ Patios/ Poolside/ Outdoors • Completely Water Proof • 3.5'' Aluminum Injection Cone Woofer • 40 Oz.
PAGE 2
FINAL ADJUSTMENTS 1. After checking that the speaker is in-phase and works correctly, angle the speaker for the best sound. 2. Hand tighten rhe bracket knobs only, power tools may over-tighten rhe knob, and strip the threads of the insert. 3. Check that the entire installatlon is safe and secure. CONNECTING YOUR SPEAKERS Connecting the speakers to your amplifier or receiver. • First turn your amplifier OFF to avoid damage which may result from accidental shorting of the speaker leads.