PCM30A 60W MAX P.A. AMPLIFIER www.pyleaudio.
IMPORTANT SAFETY INSTRUCTIONS 1. Read Instructions — All the safety and operating instructions should be read before the appliance is operated. 2. Retain Instructions — The safety and operating instructions should be retained for future reference. 3. Heed Warnings — All warnings on the appliance and in the operating instructions should be adhered to. 4. Follow Instructions — All operating and use instructions should be followed. 5.
Your new PYLE HOME PCM Amplifier gives you the power and versatility you need in a professional sound system. The wide frequency response of it handles easily amplification of voice and music. The monitor terminal, talkover function on MIC 1, and Tel/Paging make it perfectly to use in meeting halls, auditoriums, sports events in school, and paging system in offices , anywhere you need to deliver special announcement with excellent sound.
FEATURES AND CONTROLS 3 - Pyle Home PCM30A Manual
SPEAKER CONNECTION One or more speakers (4, 8 or 16 Ohms) can be connected to the amplifier with or without transformers. However, before you connect any speakers to the amplifier, the total impedance must be calculated in order to avoid damage to the amplifier. A total speaker impedance greater than 16 Ohms or less than 4 Ohms can cause this damage to occur.
SYSTEM 3 : Two (or more) Speakers in Parallel NOTE : Connect the speaker (+) to the amplifier's 4-Ohm, 8-Ohm or 16-Ohm terminal, depending on the TOTAL IMPEDANCE of the two speakers. If each speaker has an impedance of 8-Ohm, the total speaker impedance in this series configuration is 4 ohms.
CONNECTION DIAGRAM Your Pyle Home Amplifier is an example of superior design and Pyle Home PCM30A Manual - 6
Specifications Input Impedance AUX...................................200mV/50k-Ohm, Unbalanced MIC 1/MIC 2...........................1.0mV/600-Ohm, Balanced TEL/PAGE ............................100mV/600-Ohm, Balanced Max Output Power.........................................60 Watts x 1 THD at rated output power..................1% or less at 1 kHz Frequency Response +/- 3 dB..................50 Hz to 15 kHz Signal to Noise Ratio A-Weighted MIC................................................................
