User Manual



Model:

PSCBLKIT22

PatchCableLengthSetup&Connection



Youcanassemblethecableconnectionintwodifferentmethods:StraightorRight‐AngleProfiles.



StraightProfileConnection:

Runthecablethroughthecapconnectorfirstly.



Cutthecabletothedesiredlength,thenusetheequippedcablestrippertostripthecableaspicturedbelow,

revealingabout¼’’oftheinnerredwire.



Enlargethecenteroftheinnerredwire.Thiswillensureaproper

connectiononcetheconnectorisinserted.



PAGE 1
Model: PSCBLKIT22 Patch Cable Length Setup & Connection You can assemble the cable connection in two different methods: Straight or Right‐Angle Profiles. Straight Profile Connection: Run the cable through the cap connector firstly. Cut the cable to the desired length, then use the equipped cable stripper to strip the cable as pictured below, revealing about ¼’’ of the inner red wire. Enlarge the center of the inner red wire. This will ensure a proper connection once the connector is inserted.
PAGE 2
Add the connector firmly onto the exposed red wire ‐‐ ensuring the inside needle of the connector reaches the center core of the cable. Apply firm pressure and rotate/turn the connector to ensure secure contact. Then, screw and tighten the cap to the connector base. Use a small screwdriver to tighten the fastening screw securing the connection of the connector to the cap. Repeat the above steps to secure the other end of the patch cable.