User Manual

www.PyleUSA.com
OPERATION
7
TRUN ON/OFF THE UNIT
Press PWR button (1) to turn on the unit.
When the unit is on. Press and hold PWR
button (1) for 2 seconds to turn the unit o.
SOUND ADJUSTMENT
Press SEL button (1) shortly to select below
settings:
BASTRELOUDEQLOCSTVOL
MCU version DVD version
BAS: Bass
TRE: Treble
LOUD: Loudness
EQ: Equalization
LOC: Local
VOL: Volume
In each item, by rotating the audio knob (1) it
is possible to adjust the desired sound quality
or setting.
LOUDNESS
LOUD On: Boosting the low frequency gain
for 15dB around in small volume.
LOUD O: Don’t boost the low frequency gain.
LOC ON/OFF
LOC On: To reduce the receiving sensitivity
when you search station. That means you can
receive the station that sounds good.
LOC O: Don’t reduce receiving sensitivity
when you search the station. That means you
can receive more stations.
STEREO/MONO FUNCTION
STEREO: Receiving FM stereo signal.
MONO: Change to monochrome when the
signal is not good. Changing it to MONO
mode will reduce the noise.
ALARM ON/OFF
Press ALARM ON/OFF button (5) to turn
on/o alarm function.
SETTING THE ALARM TIME
Press and hold the ALARM SET button (4) for
2 seconds. The “HH” will ash.
Rotate the VOL control (1) to adjust the hour.
Press ALARM SET again the “MM”
will ash. Rotate the VOL control (1) to
adjust the minutes. Press the ALARM SET
button (4) again to store the alarm time.
STOP THE ALARM OUTPUT
When time ran to the alarm time. The
head unit will output the alarm sound.
Press the ALARM ON/OFF button(5) to
stop the alarm output.
BRIGHTNESS OF THE LCD
Press the DIM button (6) to adjust the
LCD brightness from “DIMMER 1”
(brightest) to “DIMMER 2”(less bright)
CLOCK DISPLAY
Press DISP button (17) to display the time.
5 seconds later it will turn to current
position.
CLOCK SETTING
Press and hold the DISP button (17) for 2
seconds to access clock setting mode. The
“HH” will ash. Rotate the VOL control (1)
to adjust the hour. Press DISP again the
“MM” will ash. Rotate the VOL control (1)
to adjust the minutes. Press the DISP
button again to exit clock setting mode.
VOLUME CONTROL
There are 3 pair speakers output . Press
A/B/C button to adjust A/B/C speaker’s
volume independently.
ARC FUNCTION
Connecting the head unit and TV set used
a HDMI wire. Press MODE button switch to
ARC mode. The TV set’s sound will
transmit to the head unit’s speakers.
AUXILIARY A/V INPUT FUNCTION
Press the MODE button (15) to access
AUX1(front) or AUX2(rear) input mode.
The unit can be connected to the
Audio/Video input through the AV IN jack
(22) or Inputs on the back of the unit.