User Manual

www.PyleUSA.com
18
TROUBLESHOOTING
Before going through the checklist, check the wiring connection. If any of the problems
persist after checklist has been made, consult your nearest service dealer.
Symptom
Cause
Solution
No power.
The car ignition switch is not
on.
If the power supply is connected
to the car accessory circuits, but
the engine is not moving, switch
the ignition key to “ACC”.
The fuse is blown. Replace the fuse.
Disc cannot be
loaded or
ejected.
Presence of CD disc inside
the player.
Remove the disc in the player, then
put a new one.
Inserting the disc in reverse
direction.
Insert the compact disc with the label
facing upward.
Compact disc is extremely
dirty or detective disc.
Clean the disc or try to play a new
one.
Temperature inside the car is
too high.
Cool o or until the ambient
temperature return to normal.
Condensation. Leave the player o for an hour or so,
then try again.
No sound.
Volume is in minimum Adjust volume to a desired level.
Wiring is not properly
connected.
Check wiring connection.
Sound skips.
The installation angle is more
than 30 degree.
Adjust the installation angle less
than 30 degree.
The disc is extremely dirty
or defective disc.
Clean the compact disc, then try to
play a new one.
The operation
keys do not
work.
The built-in microcomputer is
not operating properly due
to noise.
Press the RESET button.
Front panel is not properly x into its
place.
The radio does
not Work. The
radio station
automatic
selection does
not work.
The antenna cable is not
connected.
Insert the antenna cable rmly.
The signals are too weak. Select a station manually.