User Manual

EN
18
Troubleshooting
If you experience any problems with the unit, please take a moment
to look through this chart and see if you can solve the problem
yourself before you call your dealer.
No power
-► Check the connection to the AC power source. Check and
make sure the AC source is not a switched outlet and if it is, the
switch is turned on. Make sure there is power to the AC outlet
by plugging another item such as a lamp or fan.
No sound.
-►Adjust the volume,
The sound is noisy.
-► The unit is too close to a TV set or similar appliances. Relocate
the unit further away from them, or turn the other appliances off.
Tuner can’t receive any station or signal is too weak.
-►Tune in the station properly.
-►If a TV is near the unit, turn it off.
-►Rotate the unit or antenna wire for the best reception position.
Record Player does not play.
-►Turn the VOLUME knob clockwise, and turn the function to
AUX/PH mode
-►Loosen the screw, and detach the stylus guard.
(The stylus guard is a white plastic cover that protects the
stylus during transportation. Failing to remove this guard will
not allow the needle to touch the grooves of the record and no
sound will be heard)
-►lf the stylus is worn-out, change the stylus.
-►Select the correct speed (33-1/3, 45 or 78rpm).
CD Player
Does not play.
-►Turn the VOLUME knob clockwise, and turn the function to CD
mode
-►Load a disc with the playing side facing down.
-►If the disc is dirty, clean the surface of the disc.
-►A blank disc has been loaded. Load a pre-recorded disc.
-►You cannot play back unfinished CD-R/CD-RW/CD-MP3 discs.
Finalize such a disc in a CD recorder and try again.
USB/SD Card Player
Does not play
-►Some USB flash drives and SD cards may not be compatible with
this unit.
-►Please check the specification on the last page of this manual.
If normal operation cannot be obtained, unplug the power cord
from the outlet and plug it again.
Beware of condensation
When the unit (or a record/disc) is moved from a warm to a cold
place, or used after a sudden temperature change, there is the
danger of condensation; vapor in the air could condense on the
internal mechanism, making correct operation erratic or
impossible. To prevent this, or if this occurs, leave the unit turned
on for one or two hours.
Maintenance
Always keep the turntable clean.
If the surface of the unit gets dirty, wipe with a soft cloth or use a
diluted mild liquid soap. Be sure to remove any excess liquid
completely. Do not use thinner, benzine or alcohol as they may
damage the surface of the unit. Allow the surface of the unit to dry
completely before using.