TABLE OF CONTENTS Contents SAFETY INSTRUCTION * Safety instructions * Battery and Recharging instructions PRODUCT FEATURES MAIN BODY AND ACCESSORIES BATTERY INSTALLATION AND REMOVAL RECHARGING BATTERY GENERAL OPERATION * Starting Operation SIDE BRUSH INSTALLATION CLEANING AND MAINTENANCE * Cleaning Dust Bin * Cleaning Intake TROUBLESHOOTING www.PyleUSA.
SAFETY INSTRUCTIONS Before using this product, please read the safety instructions and follow all normal safety precautions. 1. Read this user manual thoroughly and carefully before using this product 2. Keep this manual in your sight. 3. Any operation oppose to descriptions in this user manual may lead to harm to human or this product. Safety Instructions 1. Only use the product indoors, do not use it outdoors. 2. Before starting the product, make sure the dust bin filter is properly installed. 3.
PRODUCT FEATURES This revolutionary Mini Robotic Vacuum Cleaner is equipped with functions suitable for cleaning up floor surfaces of home and office, such as wood, tile, and linoleum. The Mini Robotic Vacuum Cleaner is definitely a good household helper. Random Spiral Along the wall MAIN BODY AND ACCESSORIES Main body x 1 Filter x 1 Rechargeable battery x 1 User Manual x 1 2 www.PyleUSA.
MAIN BODY AND ACCESSORIES 3 www.PyleUSA.
PRODUCT FEATURES 1. Before installing or removing the battery, the product must be disconnected from the power source. 2. Open the battery cover. 3. Insert the battery into the battery cabinet and close the cover. Make sure the cover clips well located in its position. 4 www.PyleUSA.
RECHARGING BATTERY 1. Before charging, make sure the battery is correctly installed. 2. The procedure of charging the product is as follows: firstly, connect the adapter output into the DC jack, and then plug into power socket of the other end, a blue light will flash. 3. After fully charged, the indicator light will turn to solid blue light. 4. When the product runs out of power, LED indicator will turn red, which prompts the user to charge the product. 5.
GENERAL OPERATION Starting Operation 1. For first use, take out the insulating strip in battery cabinet as shown in figure below, and then put back the battery cover. 2. Place the product in a room with much free space, and then power it on to do cleaning work. 3. When the product runs out of power, the LED indicator in the illumination ring will turn red which the product will stop working. Note: * This product is not suitable for long-pile carpets.
CLEAN AND MAINTENANCE Cleaning Dust Bin 1. Open the upper cover by lifting the lid near the power on/off button. 2. Put your finger into the dust bin groove and grip to take it out. 7 www.PyleUSA.
CLEAN AND MAINTENANCE 3. Open the dust bin lid 4. Take out the inner filter 5. Empty the dirt in the dust bin. 5 8 www.PyleUSA.
CLEAN AND MAINTENANCE Cleaning Dust Bin 1. Rinse the dust bin with tap water.Do not wash it in washing machine,dish-washing machine or other machine. 2. Periodically clean the filter with a soft bristle brush. 3. Reinstallthe filter and the dust bin lid once they get dried. 4. Put back the dust bin into the cleaner. NOTE: Before putting back the dust bin, please make sure the PE pad (function as non-return valve) in the dust bin is well attached. Recheck the filter also before operating the product.
CLEAN AND MAINTENANCE Cleaning intake After repeated use for some time, dirt and dust might accumulate around the intake of the product, to ensure its best cleaning efficiency and constant airflow it should be cleaned periodically. 1. Remove the external power source. 2. Clean up the dirt and dust at the intake. 10 www.PyleUSA.
TROUBLESHOOTING Problem Possible Cause 1. Recharge the battery 1. Battery Low condition 2. Replace the robot on 2. Main body is picked up the floor 1. Clean the dust bin 1. The dust bin is full 2. The filter is not installed 2. Re-install the filter correctly correctly 1 Red LED stays after power on 2 Vacuum on but can not collect dirt and hair 3 1. The product is on dark The product is colored floor moving backwards 2.