Bluetooth Turntable Player with/ AM/FM Stereo Radio and USB Flash Drive PTT25UBT INSTRUCTION MANUAL www.pyleaudio.
IMPORTANT SAFETY INSTRUCTIONS: 1. Read the instructions. All uses guidelines, must be read before powering device. 2. Keep the instructions for future use. 3. Attention, use and security guidelines must be respected. 4. The device must not be used near water or be put in contact with moisture. 5. Make sure that no liquid is spilled on device and device openings. 6. Move device carefully, avoid shocks. 7. Do not block the device outputs. 8. Do not place the device near a heat source (e.g. radiator).
BATTERY INSTALLATION The battery compartment is located on the back of the remote control. 1. Remove the battery compartment door by pressing in on the tab and lifting it off. 2. Insert two (2) AAA size batteries (not included) into the battery compartment following the polarity markings inside the battery compartment. 3. Replace the battery compartment door. Battery Precautions z Replacement of batteries must be done by an adult. z Do not mix old and new batteries.
LOCATION OF CONTROLS 1) 2) 3) 4) 5) 6) 7) 8) 9) 10) 11) 12) 13) 14) 15) 16) 17) 18) 19) 20) 21) 22) 23) 24) 25) 26) 27) 28) Record Button Repeat/Random button Radio Band Selector Loud speaker USB Socket Dial scale Function knob FM Stereo LED Indicator Remote sensor Skip Up / Down Button Play/Pause/Stop Button +10 Button Record LED indicator Play LED indicator Repeat/Random indicator Bluetooth indicator Power On/Off-Volume knob Tuning Knob Power LED indicator Spindle Adaptor Turntable Speed Selector Auto St
Hints for best reception:- AM : The receiver has a built-in bar antenna. If AM reception is weak. Slightly rotate or re-positioning of the unit will usually improve the AM reception. FM : The receiver has a built-in FM Wire Antenna (26) hanging at the rear cabinet. This wire should be totally unraveled and extended for best reception. Listening to Phono NOTED: - Remove the stylus protector. Be sure that the tone arm is detached from the tone arm rest before operating and re-secured again after wards.
z Play / Pause / Stop mode 1. To interrupt, press the “Play/Pause/Stop button (10) once, the Play LED indicator (14) will be flashing. Press again to resume normal playback. 2. If you press and hold the “Play/Pause/Stop button (11) for two seconds during playback mode. The system will go to stop mode. 3. To start playback again, press the “Play/Pause/Stop” button (11) to start playback, the first track will start playback and the Play LED indicator (14) will light up.
Encoding of Phono into MP3 file The system is able to encode the Phono to MP3 format and recording at memory media with USB connected port (support maximum up to 2GB memory size). A) Phono encoding 1) Set the Function knob (7) to “Phono/Aux” made and then press “ Rec” Button(1). 2) The Record LED indicator (13) will light up. Now the system was ready to encoding. 3) Start playback on the location of the track which you want to record to USB.
Removing of USB To remove the USB, turn off the power or switch the function mode to either Phono or Tuner first. For USB port -unplug it by pulling out the USB socket directly. Line out connection You can connect the system to your whole Hi-Fi system by connecting the Line out Socket (25) to the auxiliary input socket with a RCA cable (not included). Remote control transmitter Battery installation (battery not provided) The Infra-Red transmitter requires 2 pcs AAA size battery for operation.
