User Manual

IMPORTANT: This Chest Belt must be worn directly on your skin. DO NOT wear the chest belt on the top of your
clothes, otherwise the chest belt CANNOT get the heart rate signal.
NOTE: In dry seasons, wet the contacts with water to make the signal transmission normal.
1 2
3
6
4
5
Extend the elastic band for
allowing a loose fitting the
chest belt on your chest.
C o n n e c t t h e o p p o s i t e
connector to the chest belt
with the another hand.
Connect one connector
with the chest belt. Ensure
t h a t th e c o n n e c t o r is
completely lodged into the
chest belt.
Fasten the elastic band
until it is fitted on your
chest comfortably.
Fit the chest belt on your
chest with one hand.
Move the chest belt until
the two contacts are firmly
contacted with the skin of
your chest.
4.0 Wear the Chest Belt
Precautions / Tips
+
+
+
+
+
+
+
+
There are two contacts located on the back of the Chest Belt. These two contacts must
make firm contact with the user's skin during measurement.
DO NOT take heart rate measurement when diving or under water.
Clean the contacts occasionally by applying a few drops of water, and wipe it dry with a
paper towel to remove any residual grease.
DO NOT use hand cream; it will insulate the signal between the skin and the contacts.
Clean your skin with soap and water for a better signal transmission.
For those with extremely dry skin, apply some conductive gel or water to increase
conductivity.
Adjust the Chest Belt with the supplied elastic band until it holds on your chest firmly to
avoid loosening when exercising.
Avoid doing any awkward motion during measurement, it will create an inaccurate heart
rate reading.
3