User Manual
www.PyleUSA.com
6
OPERATION
To use the power supply after you connect the device to it, set POWER to turn it ON
with the red led light illuminated.
If the power supply's POWER switch does not light, check all connections and
conrm the wall AC outlet has power.
If the outlet has power, set POWER to OFF, reduce the load (by using a device that
does not require more that 30 amps), then set POWER to ON. Your power supply's
overload protection circuit automatically shuts down the power supply when it is
overload and resets by turning POWER to OFF.
Caution: Place your power suppply in a well ventilated open and cool area.
Do not block the openings of the fan suction on the sides and the discharge openings
on the bottoms.
Cauton: To reduce the risk of energy hazard, be careful not to short the output
terminal during operation. Remove the output connections after use.
Caution: Your power supply might cause TV or radio interference even when it is
operating properly. To determine whether your power supply is causing the
interference, turn off your power supply. If the interference goes away, your power
supply is causing it.
Try to liminate the interference by:
• moving your power supply away from the receiver.
• connecting your power supply to an outlet that is on a different electrical circuit
from the receiver.
• contacting a qualied service technician for help.
Specifications are typical; individual units might vary. Specifications are subject to
change and improvement without notice.