User Manual

www.PyleUSA.com
11
1. Before inserting Adapter, set down scanner on at, stable surface with LCD display facing you.
2. Use included Cleaning Brush to gently wipe scanner lens.
3. DO NOT insert any plates from the left side of the unit.
4. Ensure “This Side Up” side of Adapter is facing upwards.
5. Ensure small arrow on Adapter is facing leftward.
6. From right side of unit, slide Adapter inward until it clicks.
7. To use Super8 or 110 lnsert, open Negative Adapter fully and place on at surface.
8. Ensure “This Side Up” side of insert is facing upwards.
9. Ensure small arrow on lnsert is facing leftward.
10. Place insert onto lower panel of Negative Adapter, and align in place with Adapter’s square cutout.
11. Close Negative Adapter and press until it clicks.
12. From right side of scanner unit, slide Adapter inward until it clicks.
Note: Our 126KPK Super8 Slide & Negative Scanner is a premium model.
Unlike cheaper models that require the user to t each strip of lm into an Adapter or lnsert before
inserting into unit, this scanner allows you to easily capture and convert one lm after the other. Simply
click the Adapter/lnsert in place, and feed your lms into it at will.
WORKING WITH YOUR FILMS
Now that your Adapter/lnsert of choice is properly inserted into the scanner, it is time to begin insert-
ing your lms into the device:
1. For a clear image, clean lms with soft cloth or compressed air (not included) prior to inserting them into
Adapter.
2. Negatives and slides should be inserted with their shiny side up, while Super8 lms should be inserted
with their perforated holes at the topside.