User Guide


www.PyleAudio.com
SafetyNotes
Protecttheunitfrommoistureorrain.
Keeptheunitinawellventilatedenvironmentandkeepawayfrom,directsunlighttopreventunitfromoverheating.
Don'tusevolatileordangerouschemicalcleanersontheunit(liketoluene,alcohol,gasolineetc.)Usegentlecleaners.
Donotopenchassis!Extremelydangerous!Do
notputyourhandsinsidethechassis.Ifthedevicebeginstomalfunctiondonot
attempttorepair,unplugtheunitandcontactPyleimmediately.
Carefullyhandle,plugandunplugthepowercablewhenhandling.Holdtheplugwithafirmgripandwhenpluggingor
unpluggingfromsockets.
Correct
powermustbeusedtooperatethisunitproperly,donotuseanyotherpoweringoptions,cordsormethods.
PowerOn
ThePAspeakercanbepoweredwhenconnectedtomainpowerorusingtheinternal12Vbattery.
1.Connectthepowercabletotherearoftheunit.
2.Connecttheotherendofpowercabletomainpower.
3.Turnonthemainpowerpoint.
4.Theunitwillautomaticallypoweron
whenconnectedtomainpower.
Notes:Ifyouwishtousetheinternalbatterytopowertheunit,justsimplyturnonthePowerswitchlocatedonrearpanel.
Charging
BeforeusingthePAspeakerforthefirsttime,chargetheunitatleast8hours.
1.Connectthepowercableattherearofthepanel.
2.Rechargeindicatorlightwillbe onwhenitischarging.
Notes:Theinternalbatterywillchargewhiletheunitisbeingoperatedandthe
powerswitchison.Itisbetterto
chargetheunitwhilethepowerswitchisoff. 
UsingtheWiredMicrophone
YoucanconnectthewiredmicrophonetothisunitusingtheMICINPUTlocatedontherearpaneloftheunit.
1.Turnontheunit.
2.ConnectyourwiredmicrophonetotheMICINPUTlocatedattherearpaneloftheunit.
3.Adjustthemicrophonevolumebytuning
theMICVOL/ECHOknobslocatedattherearpaneloftheunit.
NOTES:Youcanusethewiredmicrophoneandwirelessmicrophoneatthesametime.
