User Manual

18
TROUBLESHOOTING
Before going through the checklist, check the wiring connection. If any of the problems
persist after checklist has been made, consult your nearest service dealer.
Symptom Cause
Solution
No power.
The car ignition switch is
not on.
The fuse is blown. Replace the fuse.
Disc cannot be
loaded or
ejected.
Condensation.
No sound.
Volume is in minimum Adjust volume to a desired level.
Check wiring connection.
Sound skips.
Clean the compact disc, then try to
play a new one.
The operation
keys do not
work.
Press the RESET button.
Front panel is not properly fix into
its place.
The radio does
not Work. The
radio station
automatic
selection does
not work.
Insert the antenna cable firmly.
The signals are too weak. Select a station manually.
If the power supply is connected
to the car accessory circuits but
the engine is not moving,
switch the ignition key to “ACC”.
Remove the disc in the player
and replace with a new one.
Presence of CD disc
inside the player.
Inserting the disc in
reverse direction.
Insert the compact disc with
the label facing upward.
Compact disc is extremely
dirty or defective disc.
Temperature inside
the car is too high
Cool off or until the ambient
temperature returns to normal.
Leave the player off for an hour
or so, then try again.
Adjust volume to a desired level
Wiring is not properly
connected.
The installation angle is
more than 30 degree.
The disc is extremely dirty
or defective disc.
The built-in microcomputer
is not operating properly due
to noise
The antenna cable is not
connected.
www.PyleUSA.com