User Manual

PLMRSBA10

Marine Grade Slim Active Subwoofer

10” 900 Watts Low-Profile Active Amplified Marine

and Waterproof Subwoofer System

Suitable for Under-seat Installations

Questions? Issues?

We are here to help!

Phone: (1) 718-535-1800

Email: support@pyleusa.com

PAGE 1
Questions? Issues? We are here to help! Phone: (1) 718-535-1800 Email: support@pyleusa.
PAGE 2
Introduction Control Panel and Features 3 With the PLMRSBA10, we are introducing a low-profile amplified subwoofer. Low enough to easily fit below the seat of your car. This system offers you a quick and easy way to add a high-powered subwoofer system to your audio system. 5 7 9 The integrated amplier in the PLMRSBA10 features low pass crossovers, and a control for adjusting the input sensitivity from 0.12V to 3.5V.
PAGE 3
Low Level Input Wiring Power Connections Low-level (RCA) input wiring is preferred for best audio performance. Most trunk or hatchback installations will require a 15-20 foot RCA cable, while pickup trunks and under-seat installations will require a 6-12 foot RCA cable. Always use a highquality cable. Connect the ground terminal to the closest point on the chassis of the vehicle. Keep this ground wire to less than 39” (100 cm) inlength. Use 8 gauge (or heavier) wire.
PAGE 4
Troubleshooting Features: If you experience operation or performance problems with this product, compare your installation with the electrical wiring diagram on the previous pages. If problems persist, read the following troubleshooting tips which may help eliminate the problems. • 10" Slim Woofer • Low-Level RCA Input • High-Level Speaker Line Input PROBLEM POSSIBLE REASON NO +12v to power wire Not switching on.