User Guide

www.PyleUSA.com

BASS BOOST CONTROLS

This ampliﬁer has Bass controls for making good sound combination.

FUSE

The ampliﬁer is equipped with a plug-in auto fuse protecting the set against

fault conditions. Do not use a fuse with a higher value and never bridge the fuse

over, as this may lead to irreparability damage so that any claim for warranty is

denied.

GND (-) = GROUND CONNECTION

Connect the GND terminal to the chassis ground of your car and take care of

best electric and mechanic contact.

ln doing so, drill a hole in to the car chassis near the ampliﬁer then remove

color, dirt, or any other substance from the ground point.

Thereafter fasten the cable end with added ring terminal by using a screw.

Ensure that the ground connection is as short as possible and that the cable

diameter is suﬃcient (min 4mm”).

Route the ground cables from the radio and all other equipment parts, like

equalizer, active crossover network or other ampliﬁers, to the same ground

point.

+ 12V = POWER SUPPLY

Connect the BATT terminal to the positive pole of the battery with a lead cable

and add a fuse into the power cable in a distance of not more than 30 cm from

the battery. The lead cable's diameter should be at least 4 mm’ for a length of

3 m and 6mm" for a length of 6m.

REM (ON/OFF) REMOTE CONTROL

Connect the REM terminal to the automatic antenna connector of your car radio.

Now when turning ON and OFF your car radio, the ampliﬁer automatically

switches ON and OFF. A cable diameter of 0.5 mm’ is suﬃcient.