User Guide

Elite Series Waterproof Amplifiers
Speaker negative terminals on the amplifier are not used in the bridged mode.
Bridging is done by using multiple channels of an amplifier to drive a common
load. Bridging means that you will use more than one source of power to drive a
load (speaker). The sources of power are the independent channels of the
amplifier.
Power Connection
Connect the +12V of the amp to your vehicle's battery (+)
Connect the GND of the amp to your vehicle's battery (-), ground properly
Users may also reinforce the ground connection by adding another connection of gauged
wire from the (-) negative battery terminal to the chassis of the stereo unit.
Connect the 'Remote' of the amp to your vehicle's external switch for a positive
12V ON/OFF connection.
This may be connected to the receiver power antenna lead
(Amp turn on) -- typically blue in color.
Some users may automatically set the gain to maximum because they want their music loud, by doing so, they
are also increasing the chance of burning out their amplifiers. Please follow the instructions found in this
manual to help match the signals correctly. Your system can also become extremely sensitive to noise
conditions when you have a high signal level coming Into the amplifier, from your connected source, which
should be adjusted accordingly. Avoid problems and match your system levels correctly!
Power
Connection
Visit www.PyleAudio.com for detailed model information and connection ability.
Models: PLMRA210BT, PLMRA410BT, PLMRA430BT, PLMRA630BT, PLMRA830BT