User Guide

Elite Series Waterproof Amplifiers
BATT +12V
GROUND
REMOTE
Connect+ 12V DC power supply wire Into the terminal from the
terminal of the fuse at battery. (Fuse preferably installed 1 foot
within 1 foot from the battery).
Ground terminal connect the ground wire to the chassis of the
automobile, boat or other vehicle.
Remote terminal connects the control wire which provides
remote turn-on and power off.
6 Power on LED
When the amp is properly grounded and has proper power and
Is receiving Its remote power signal the green LED will light up
indicating power conditions are correct.
7 Protection LED
This Is Indicator Is Illuminated when built-in protection circuitry
Is activated.
8 Power Fuse
Power fuse protects both this amplifier and the automobile
electrical system from wrong electrical conditions.
9
Speaker
Terminals
The speaker terminals are silver-plated for high conductivity
and minimum Impedance loss. Be sure to strip just enough
Insulation off your speaker wires that will fit under the screw
plate to help ensure against speaker wire short circuits. The
amp
can support an impedance load as low as 2 ohms per
channel or 4 ohms in the bridged mode, though a 4 ohm stereo
load and 8 ohms bridge load will greatly Increase the life
expectancy of the amplifier.
10
Crossover
Frequency Circuit
Lets you adjust the crossover frequency from 40-450 Hz for
both channels.
11
Crossover On/Off
Switch
Allows for operation to run at full range or with built-in
crossover use.
www.PyleAudio.com
The Pyle Elite Series Amps feature options and configurations that vary
among the various models in the amplifier line availability. Refer to the
specific model number for detailed amplifier connection options and
features. Visit us online for detailed specifications and more information.