User Guide

Elite Series Waterproof Amplifiers
Elite Series Bluetooth Connection
When searching for the amp via your smartphone or other Bluetooth-enabled
device, the Bluetooth amp network name will appear as 'Pyle Amp' in your device
list. The amp will not require a password to connect. Once successfully paired with
your compatible Bluetooth-enabled device, you will be able to control music
streaming ability into the Pyle amp. Choose from streaming audio to adjusting
volume controls -- all from your device.
Mounting
Always choose a mounting location which will be susceptible to the least amount of
vibration, provides adequate ventilation, free of dust and moisture. Be sure to mount the
amp in such a manner as to allow reasonable airflow around the unit.
Mark the location for the mounting screw holes by positioning the amp in the desired
location. Located on the outer edges of the amps, you will find notches in the heatsink
that allow for the amp to be fastened. Mark the location for the mounting screw holes by
positioning the amp where you wish to install it. Use a scribe (or one of the mounting
screws) inserted in each of the mounting holes to mark the mounting surface. If the
mounting surface is carpeted, measure the hole centers and mark with a felt tip pen.
Before attempting to drill the mounting holes and securing your amp, take note of any
wires, lines or other devices within your vehicle which may be located behind the
mounting surface. Be sure as to not interfere with any of your vehicle's safety features,
wiring or other electrical systems. Then, drill the pilot holes in the mounting surface for
the mounting screws. Tighten screws securely.
Mounting
Your amp comes with all required
mounting hardware. When
determining a suitable location in
your vehicle for the amp, please
remember that this is a high-power
electronic device that is capable of
generating high temperatures