User's Manual

Installation / Mounting:
Be sure to install the U-shaped bracket so it fits flush to the interior of the mounting wall. The receiver face should sit flush on
your dash / console panel.
The two threaded bolts screw into the rear of the receiver housing. The bolts then slide through the U-shaped bracket and are
tightened from the other ends by nuts. Be sure as to avoid pinching any cables/wiring, and not too over-tighten the nuts.
Ensure a water tight seal is created between your receiver and the dash / console panel, as to not allow moisture into the
opening compartment.
*Please Note: The yellow RCA Video Connectors
can only be found on model PLMR94W.