User Manual

sensitivity (level 8=most sensitive), which can be
adjusted using the remote transmitter. To adjust the
system’s built-in shock sensor:
1. Make sure the system is disarmed and ignition is
turned o.
2. Press and hold unlock and lighting bolt buttons
together to enter adjust mode.
t The LCD remote will display a number between 1
and 8 to indicate the sensitivity level, factory set-
ting is level 5; Level 1, least sensitive and level 8,
most sensitive.
3. Press lighting bolt button to change sensitivity
level.
t The siren will chirp a number of times to indicate
the sensitivity level, example level 3 chirps and #3
displayed on LCD remote.
4. When desired sensitivity is reached, press unlock
button to conrm and exit the setting mode.
BACKUP BATTERY (optional)
A backup battery provides power to the alarm sys-
tem when the primary source of power is not avail-
able.
BATTERY MONITOR
When the lock button is press, LCD transmitter will
display the motorcycle’s battery voltage with a
ashing V icon. This will let you know the current
battery voltage of the motorcycle.
ALARM MODULE WIRING
8-Pin Main harness
Yellow WIRE’S – Flashing Light output (+12v) 10A
relay. Connect to the motorcycle turn signal wires. If
the motorcycle’s turn signal circuit exceeds 10
Amps a relay is required.
NOTE: Do not connect the YELLOW wire’s to the
Motorcycle’s headlight circuit.
t Orange WIRE - +12V Ignition input. Connect to a
main ignition wire at the ignition switch harness.
This wire shows +12V when the ignition is on and
while cranking. The voltage must not drop when
the motorcycle is starting.
t BLACK WIRES - Ground input (-) connect directly to
the Motorcycle’s battery or to a solid chassis ground
that is clean and free of paint or dirt.
t RED WIRE -Main power input (+). Using the sup-
plied inline fuse holder, connect directly to the
Motorcycle’s battery or alternate power source.
t PINK WIRE - Not used.
t GREY WIRE -Optional ignition defeat output
(-300mA); requires relay (see page 8) .
t BLUE WIRE (PLMCWD25/75)- Remote start output.
Connect to starter activation wire.
2-Pin LED Connector: Mount LED in an area where it
may be easily seen from either side of the Motorc
y-
cle. Connect the 2-wire connector to the LED plug.
2-Pin Siren Connector: Mount Siren in an area that
is not accessible from potential would be thieves.
Connect the 2-wire connector to siren plug.
FUNCTIONS
6