User Manual
www.PyleUSA.comwww.PyleUSA.com
4 5
INSTALLATION
1.Take out the machine, remove the bracket like below
2. Remove the screws from bracket like below picture.
3. Put the plastic bracket parts in between two metal poles, at the same
time, push 2 screws to x up bracket.
4. Hold up unit, insert the metal plate at the back of the unit into plastic
bracket parts, then adjust it to the right angle and x it tightly, at last lower
the orignal car headrest to the appropriate position.
Attention
1. Do not put the machine in the rain or damp environment lest outbreak of
re or any damage to machine.
2. Do not repair the machine by youself. Please turn o the machine and inform
us if any problem found, the factory or the agent will arrange specialized
personnel to disassemble and repair the machine for you .
3. Please keep the machine away from dampness, dust, oil and straight sunlight.
4. Do not use diluents or other chemical cleaner when cleaning the machine.
Please clean the machine by soft cloth with special cleaner.
5. Please keep the machine in a good environment. The storage temperature
for this machine is from -4°F to 140°F.
6. This machine only supports DIVX/MPEG4/DVD/DVDR+/SVCD/VCD/DVCD/
CD/MP3/WMA/CD-R/RW/HDCD+-R/JPEG or CD-ROM7.
7. Please prevent the machine from the inuence of other equipment.
8. For your safety, please do not turn or operate this machine when driving as it
may be illegal in some countries and regions.
9. Safe power supply: DC12V (voltage range:10V-14V)
Attention
There may be some small and bright spots on the screen. This is a common
technical matter and does not indicate any quality problem of this machine.
TROUBLESHOOTING
Troubles Solution
No sound & image
No image
No sound
Black Screen
Blurring and
Unstable Image
Color cast
No power
No image after
loading the disc
Unstable sound
caused by vibration
Unstable sound even
with no vibration
Power is disconnected; the machine is not turned ON
Disc is scratched; signal wire is disconnected
Volume too low or the volume setup is not workable
Incorrect setup of image luminance and contrast; Undervoltage
Disc is scratched
Function menu setup is incorrect; weak signal
Voltage is not accurate: check inter connect circuit;
Fuse is disconnected: change fuse specication
Only audio frequency for the disc; disc is scratched;
disc for format is not supported
DVD is dirty or seriously damaged
Disc is dirty or scratched clean or replace the disc