User Manual

www.PyleUSA.com
3
3. Please plug the round 1 mm DC plug that you just wired to your reverse
tail light into the red (A) power connection (image on page 2)
4. Use the included 5m video cable to connect the yellow video wire (B) to
your video monitor.
Attention:
The camera switch is controlled by the reverse gear shift. When you put
your car in reverse, the camera will receive its 12 V power from the reverse
tail light.
Video Cable
Video (out)
Monitor
Camera
Backup Light Power
Red: +12V (in)
Black: GND (in)