Please read instructions carefully before installation and use. Installation should be performed by a professional installer.
1. WIRE CONNECTION Please hard wire the red positive wire connected to the round 1 mm DC plug (pictured below) to your reverse tail light positive 12V connection and the black wire to the closest available ground. You will probably need a small length of wire to reach from your reverse tail light to the DC plug. 2. Please Attach the camera to your license plate bracket as shown above. You can then run your wires so that they are out of the way.
3. Please plug the round 1 mm DC plug that you just wired to your reverse tail light into the red (A) power connection (image on page 2) 4. Use the included 5m video cable to connect the yellow video wire (B) to your video monitor. Video Cable Monitor Video (out) Camera Backup Light Power Red: +12V (in) Black: GND (in) Attention: The camera switch is controlled by the reverse gear shift. When you put your car in reverse, the camera will receive its 12 V power from the reverse tail light. 3 www.PyleUSA.
