OWNER'S MANUAL MOTORIZED SLIDE DOWN DETACHABLE PANEL FM/AM BAND RADIO RECEIVER ELECTRONIC ANTI-SHOCK CD / MP3 PLAYER CD CHANGER / AUXILIARY INPUT CONTROL USB HOST DRIVE ON FRONT PANEL ENCODER AUDIO CONTROL REMOTE CONTROL MODEL: PLCDUSB78MP3 Page.
LOCATION OF CONTROLS FIGURE A REMARK : AT ANY TIME, IF THE WIRE IS DISCONNECTED, THE RESET SWITCH MUST BE PRESSED AGAIN BEFORE OPERATE THE RADIO (REFER TO PAGE 5 FOR DETAIL). OTHERWISE, THE RADIO MAY NOT WORK PROPERLY. OPERATING INSTRUCTIONS 1. POWER ON/OFF CONTROL Press the button to turn the power “ON” or “OFF”. Note : The unit can be turn on by pressing any keys on the panel (except open/close button & disc eject button). It will help the user who cannot find the power button in dark. 2.
SETTING CLOCK TIME MANUALLY Briefly press “DISP” button until clock time appear on the display. Press and hold the button until the clock flash and release “DISP” button. While clock is flashing, rotate “VOL/SEL” control clockwise to set HOUR and anti-clockwise to set MINUTE. 7. MUTE CONTROL Press the button to mute volume control and “MUTE ON” will appear on the display. 8. EJECT BUTTON Press the button to eject the disc inside disc slot. 9.
preset button can store FM1, FM2, FM3, MW1, MW2 band station frequency. Pressing the button momentarily recalls the station frequency which was memorized. There are 6 preset buttons, giving you capability of storing 18FM / 12MW. NOTE: When the preset button to be memorized is kept pressed for more than 2 seconds, the receiving station frequency will be stored in the button pressed. After this, the memorized station can be recalled by pressing the button once.
CHARACTER SEARCH (OPTIONAL) • Press “AMS” button 3 times and “CHAR SCH” will be shown on the display. • Press “VOL/SEL” control to enter into character search mode and “A” will appear on the display for you to enter first character. • Enter whole name of files (maximum 8 characters) by rotating “VOL/SEL” control clockwise or anti-clockwise to shift “A-Z”, “0-9” & “ ” (space) in loop rotation. • Press “VOL/SEL” control shortly to select the first character.
INSTALLATION REMOTE CONTROL CAUTION : DO NOT PLACE THE UNIT OVER THE M A X I M U M I N S TALLATION ANGLE OF 30°. OTHERWISE, THE UNIT MAY NOT WORK PROPERLY. WARNING!! Due to protection of CD Mechanism, two small screws on the top of the unit must be released before operate the unit. Otherwise, the CD Mechanism can not be working properly. UNIT REMOVAL 1. Remove Front Control Panel. 2. Slightly insert the key into the slot and gently to release. 3. Separate the sleeve from the unit.
