User Manual

- 14 -
TROUBLESHOOTING
The following chart will help in solving most problems that may occur.
If you still have questions after going through the checklist, please consult your local customer service
representative. Before going through this check list, refer the wiring and operating procedures.
Symptom Cause Solution
The car ignition switch has
not turned on.
If the power supply is connected to the
car accessory circuits, but the engine
is not moving, switch the ignition key
to “ACC”.
No power
The fuse has been blown. Replace a new one.
Presence of CD disc inside
the player.
Remove the disc from the player, and
insert a new one.
Inserting the disc in reverse
direction.
Insert the CD with the label facing
upward.
The surface of CD is
extremely
dirty or has been scraped.
Clean the disc or try to replace
a new one.
Temperature inside the car
is too high.
Cool off or until the ambient
temperature return to normal.
Disc can not be loaded
or ejected.
Condensation
Leave the player off for an hour or so,
and then try again.
Volume is in minimum. Adjust volume to a desired level.
No sound
The wiring is not properly
connected.
Check wiring connection.
The installation angle is
more than 30°.
Adjust the installation angle less than
30°.
Sound skips
The surface of CD is
extremely dirty or has been
scraped.
Clean the disc or try to replace
a new one.
1. The built-in micro-
computer is not operating
properly due to noise.
1. Press the RESET button to restore
the program.
The operation keys
do not work
2. The front panel has not
properly installed.
2. Fixed the front panel into its place.
No radio reception.
The antenna cable is not
connected.
Insert the antenna cable firmly into
the antenna socket of this radio
player.
In automatic search mode
the radio does not stop at
a transmitting station.
The transmission signals are
too weak.
Select a radio station manually.