User Manual
3
www.PyleUSA.com
HUD INSTALLATION :
1. Know your vehicle brand, HUD work for cars with OBDII agreement or
EU OBD agreement. Open the engine hood and nd the sticker below it
(see the below picture 1), if it has words like OBDII CERTIFIED, then it can
be installed.
2. Find out the 16 pin diagnostic link (see the below picture 2) of the
vehicle and connect it well with OBDII connecting line.
HUD SETTINGS:
Car speedometer value has been adjusted high by car factory to make
driving safe. Since HUD receiving data from ECU, thus HUD display is the
accurate value. ECU calculated data will be a little dierent with car
dashboard data. If you nd HUD display value is not same as your
dashboard, you can enter the menu setting to adjust HUD value, then
HUD display information will be the same as your dashboard.
Vertically press in the wave button 5 seconds:
Enter into menu setting (there are 3 directions for wave button: up,
vertical, down), vertical long press, enter the menu setting, vertical short
press 1 time , menu options will increase 1 unit, up and down the wave
button to increase or decrease the parameter value. After adjustment,
vertical long press 5 seconds to return the previous interface.