User Manual

USE AND INSTALLATION FOR REFLECTION FILM:

Please Note: HUD projects dashboard information on the car front

windscreen, because the windscreen is double, which will make double

reection on the windscreen when it works. The double reection will be

dierent cause of the dierent windscreen. If you can clearly see the

display information, then there is no need to use the reection lm. If

there is a double image, then please use the reection lm.

First, please put the non-slip mat on the dashboard, and then put HUD on

it. Reection lm can be stick to the position right above the HUD position

which can reect host screen to windscreen.

METHODS OF PASTING THE FILM:

1. Spray some water on the place that the lm will be pasted on, and then

use dry cloth to clean it.

2. Take o the back side（marked 1) of reection lm, then paste it to the

window glass.

3. After you have adjusted the location, you can use a scratch board or

something else at to slick the lm and squeeze the water inside out

until there is no bubble or water in it.

4. Take o the protection lm (marked 2) of the reection lm. If the lm

cannot display the whole information, please adjust the non-slip mat to

move the position.

HUD Specications:

Working voltage DC8-18V

Working current 40mA

sleeping current 15mA

Compass precision ±1°

Speed range 0-400MPH

Satellite positioning time Cold start: 30s, hot start: 1s

HUD size 90x54x12mm

12V car charger 1000mA

HUD weight 40g