Instruction manual

PC- Link Upload
1. Install the PC-Link interface program.
2. Plug the USB into the computer.
3. Within the interface program, locate the upload button and click on it.
4. The unit should display 'PC' and square boxes should appear horizontally to indicate that the
data is being uploaded.
5. Once PC upload is completed, after 3 seconds, the unit will automatically return to the
previous display.
Note:
- At anytime, press and hold the MODE/SET key to quit the memory record mode immediately
and return to the time and date mode.
- When you are reviewing data from a particular lap, to continue to view the next lap, press the
START/LAP/RESET button.
15
- Default stride setting formula before stride calibration:
WALK
Male - Height x 0.415
Female - Height x 0.400
RUN
Male - Height x 0.705
Female - Height x 0.685
- The stride length range is limited to 20 ~ 180cm (8” to 5’ 11”) for both run and walk. If the
calibration result is outside this range, the previous stride length is used.
- During stride length calibration is performing, pressing and holding MODE/SET key will
terminate the calibration process, the “calibration fail” screen will be displayed for indication.
- If stride calibration is not performed before, the stride value will be set based on Height
formula.Once the stride is calibrated, it will replace the default stride value calculated based
on Height value.
Downloading/Installing PC-Link Program
Please visit our website at http://www.anyrun.com to download the
interface program .
Note: Windows Vista may not allow the download of the program due to its security
protection software therefore we advise you to download the program using D drive.