User Manual

www.PyleUSA.com
5
www.PyleUSA.com
6
TRANSMITTER BATTERY INSTALLATION
Conference Microphone Battery Installation:
Push open the battery cover,Insert the supplied batteries into battery jar in
polarity and close the battery cover.
CONFERENCE MICROPHONE CONNECTION
1. Insert the microphone unit into the connection hole of the conferencing
unit and tighten clockwise.
2. Press and hold the POWER button to turn ON the conference microphone,
and the light of microphone will be Illuminated.
3. Select the appropriate channel with the UP button and the DOWN button
4. Short press POWER button to switch mute state (The light of microphone is
o) and normal state.
Locking Operation
• Press and hold "UP/DOWN" button, release the button once the CH number
begins to ash
• When ashing, continue to press "UP/DOWN" button to increase/decrease
the channel orderly, select the desired channel
• Once done with the channel adjustment of any module, the channels of
the other seven modules will be changed automatically without any action to
select the channels under same group.
• The channels will be save automatically for using without any action for
5 seconds.
• Please refer to the following list for showing group information.
Transmitter Operation
Power ON transmitter
• Press and hold "UP/DOWN" button, release the button once the CH number
begins to ash
• When it is ashing, continue to press "UP/DOWN" button to increase/
decrease channel orderly, select the same channel as chosen on receiver.
• The selected channel will be saved automatically without any action for 5
seconds.
3. Please pay attention: In using multi-microphones together with better
eect (less interference), we suggest to choose 8 frequencies under same
group for using.
Push down to open