• PDWM8325 • PDWM8350 • PDWM8374 PDWM8374 PDWM8325 - PDWM8350 - PDWM8374 8 Mic Professional Handheld VHF Wireless Microphone System
FOREWORD Please read these instructions carefully before operating this product and retain them for future reference. MAIN FEATURES • Uses multilevel high frequency and midfrequency narrowband filters to avoid interference. • Quartz crystal oscillating circuits guarantee a steady frequency. • Audio compression and expansion technology to increase the dynamic range and lower feedback.
TECHNICAL PARAMETERS UNIT SPECIFICATION Modulation FM T.H.D -0.8% Distance 50-100M Temperture 14-131°F RECEIVER S/Noise Ratio ≥105dB Removing weight 50ms Audio output 0-0.35Vp-p 5k Output connection 6.3 mm plug/XLR Power supply DC:12-17V 3 www.PyleUSA.
TECHNICAL PARAMETERS HANDHELD TRANSMITTER 1. Mic Grill 2. Power ON Indicator 3. Power ON/OFF switch 4. Low voltage indicator 5. 9V Battery 6. Battery cover LAVALIER TRANSMITTER 1. Power ON/OFF switch 2. Power ON Indicator 3. Low battery LED 4. Install Battery box 5. Battery compartment 6. MINI XLR jack 7. Volume Control 8. Antenna OPERATION 1. Please put the battery in the battery case correctly with right poles 2. Switch ON 3. Please take out the battery and switch it OFF if you will not use it. 4.
TECHNICAL PARAMETERS FRONT PANEL Pr ofessional Wireless Microphone 1. Power Switch 2. LCD Display 3. RF Indicator BACK PANEL 1. Antenna 2. Volume Controls 3. Unbalance Output 4. Balance Output 5. DC Power Input 5 www.PyleUSA.
SYSTEM OPERATION 1. Please take note of the following workflow diagram for reference on connecting this machine. Connect the mix out of receiver with mic input on the amplifier or out A, B, C, D and mic input on the amplifier. 2. Make sure your system is set to the correct power (120V/240V) before switching the unit ON. Then set the volume of your sound equipment. 3. Adjust the volume and mic so that the users of MIC 1 and MIC 2 sounds good together. 4.
TROUBLESHOOTING Some common problems and their solutions are printed below. PROBLEM No sound; RF light(s) not glowing No sound; RF light(s) not glowing Received signal is noisy; contains extraneous sounds with transmitter on. SOLUTION • Make sure the transmitter • POWER switch is ON and the receiver is plugged into a power source • Check battery. • Check receiver squelch setting. • Check receiver antenna connection(s). • Make sure antennas are in line of sight of transmitter.
• PDWM8325 8-Ch. Wireless Microphone System, UHF Microphone Receiver Kit with (8) Mics, Rack Mount • PDWM8350 8-Ch. Wireless Microphone System, UHF Microphone Receiver Kit with (4) Handheld Mics & (4) Beltpack/Headset Mics, Rack Mount • PDWM8374 8-Ch.
