3'' 3-Piece Kids/Junior Drum Set Metallic Drum Set with Throne, Cymbal, Pedal, Bass Drum, Tom and Drumsticks
CONTENTS CHECKLIST First, check the contents of the package and make sure you have everything you need. 1. Bass Drum Head 10. Bass Drum Spur 2. Drum Mute Mat 11. Cymbal Holder 3. Cymbal 12. Drum Tuning Keys 4. Snare drum 13. Pedal Heads 5. Tom Tom 14. Throne Pedestal 6. Bass drum 15. Tom / Snare Drum Holder 7. Accessory Box 16. Drumstick 8. Pedal 17. Throne seat 9. Bass Drum Bolts ASSEMBLY INSTRUCTIONS 1. Take out all the parts from the package and remove the packing bags.
2. Take all the accessories from the accessories box 7. 10 11 9 12 8 17 15 13 14 16 3. Set up the seat from 14 and 17. Seat Wing bolt www.PyleUSA.
. Set up the pedal from 8 and 13. 5. Set up the bass drum: take out the bass drum no. 6, remove one side bolt and hoop 4 www.PyleUSA.
Put the washers on the bass drum boles and put the drum head on. Please pay attention the logo position when you put the drum head on. Using the tuning key to make the drum head tight. Please pay attention that, don’t tighten one screw too tight without tightening other screws. The correct way is tighten one screw a little, and then tighten the opposite screw a little, then tighten the besides screw a little, then tighten the left screw a little. Then tighten again by this turn. www.PyleUSA.
. Set up the bass drum spur 10. Insert it inside the slot of the bass drum in both side. 7. Put the bass drum on the floor and adjust the length of the bass drum spur. 6 www.PyleUSA.
8. Set up the cymbal holder 11 and tom/snare drum holder 15 on the bass drum. 9. Set up the cymbal. 10. Set up the tom drum on the right, snare drum on the left. Put the logo on drum head in the correct position as picture. www.PyleUSA.
Set up the pedal on the bass drum hoop by using the screw as below picture. 11. Finish 12. If you are afraid it is too loud to annoy your neighborhood, you could put the drum mute mat no. 2 on the drum head. 8 www.PyleUSA.
Setting drum mute mat method as below: 1. For snare drum and tom drum, you could just put the mute mat on the drum head. 2. For cymbal, you need to take the screw and upper felt out, and put the mute mat instead. Take this upper felt out 3. Set up the bass drum mute mat. At first, tear the adhesive tape and stick it on the bass drum. 4. Finish www.PyleUSA.
Questions? Issues? We are here to help! Phone: (1) 718-535-1800 Email: support@pyleusa.
