Read Instructions — All the safety and operating instructions should be read before the appliance is operated. 2. Retain Instructions — The safety and operating instructions should be retained for future reference. 3. Heed Warnings — All warnings on the appliance and in the operating instructions should be adhered to. 4. Follow Instructions — All operation and use instructions should be followed. 5.
Your new Pyle Amplifier: Gives you the power and versatility you need in a professional sound system. The wide frequency response handles easily amplification of voice and music. The signal sensing of dual inputs turns the amplifier on automatically when music is sensed on RCA inputs. The activation of Line 1 input, will override Line 2 input, making the amplifier perfect as a zone amplifier for multi-room distribution audio systems.
FEATURES AND CONTROLS 1. Power On/Off with indicator inside Main power switch, it will light when the amplifier is turned on. 2. Speaker A/B Channel Input Selectors with indicator inside Lets you select speakers you want to use with the amplifier in channel A or Channel B. 3. Balance Control Lets you adjust the volume of the left and right outputs. 4. Volume Control Lets you control the total of output power level. 5.
input mode to provide over 160 watts RMS mono output. For mono application use only the R+ and L- of SPEAKER A channel output. Please preset the volume control at MIN and adjust to the desired level. 11. Auto On Switch Lets you select AUTO position to activate the amp automatically when the signal is sent to input source, the amp will shut down automatically after a period of time without the signal source is sent, please preset the Power On/Off switch to ON position in this application.
CONNECTION CONNECTION DIAGRAM-A: In this application the TV audio signal acts as “Priority” source at Line 1 input and a distributed audio signal from the other audio system acts as “Primary” source at Line 2 input. Whenever the TV is activated, its signal overrides the distributed signal of Line 2, only the TV audio will be heard via the amp, but the distributed audio of Line 2 input will still be present at Line 2 Output and sent to additional zone.
CONNECTION DIAGRAM-B: In this application a computer’s sound card acts as “Priority” source at Line 1 input and the TV audio signal acts as “Primary” local source at Line 2 input. Whenever the computer is activated, its signal overrides the TV signal of Line 2, only the computer audio will be heard via the amp. Once the computer is turned off, the amp will switch to the TV automatically as an audio source, if the TV is still active.
