INTRODUCTION PYLE amplifiers provides high-performance sound reinforcement for your mobile audio equipment. Its versatility enables compatibility with optional Equalizers, Frequency Dividing Crossover Networks, and other audio processors in customized system. The Multi-Mode bridging capabilities allow flexibility in hosting several different speaker configurations. To achieve optimum performance, it is highly recommended that you read this Owners Manual before beginning installation.
PLANNING YOURSELVES Before beginning the installation, consider the following 1. Bo you plan to add additional mobile electronics equipment in the Nature? If you plan to expand your system by adding other components sometime in the future, ensure adequate space is left, and cooling requirements are met. 2. Should you use high or low level inputs? Your Amplifier has been designed to accept Low-Level (Pr-Amp outputs from your radio) signal source.
1. Ground: To Vehicle Chassis To avoid unwanted ignition noise caused by ground loop, it is essential that the Amplifier be grounded to a clean, bare, metal surface of the vehicle's Chassis. NOTE: GROUND WIRE SHOULD NOT BE EXTENDED MORE THAN 3 FT, (1 METER). Volt (Fused) Constant Power: To Battery Due to the power requirements of the Amplifier, this connection should be made directly to the positive terminal of battery.
PANEL LAYOUT INV500DBA/ INV1000DBA FRONT VIEW 7on wow our EN (EF: SEB INVASION/ INVIOLABLY FRONT VIEW 2 0886 O[== 800 CORE w=) = S SEE -§m® QO (mc® 0 28 WL. INV500DBA REAR VIEW SPEAKER QRTPLT @ www.
CONTROL FUNCTIONS 1. RCA Input jacks These RCA input jacks are for use with source units that have RCA or Line level outputs. A source unit with a minimum level of 200mV is required for proper operation. The use of high quality twisted pair cables is recommended to decrease the passivity of radiated noise entering the system. 2.GAIN Control The level control will match the amplifiers sensitivity to the source units signal voltage. The operating range is 200mW minimum to 6W maximum.
7. Auxiliary Outputs The Auxiliary outputs offer PYLE amplifiers easy, unlimited system expansion. Route RCA, from the line out of the first amplifier to the line input of a second amplifier when using a single source output. 8. PHASE: Allows you to invert the sub woofer phase from 0 to 180. 9. SUBSONIC: The frequency can be adjusted between 10Hz and 50Hz. 10. REMOTE Controls the sub woofer amplifier gain from a remote location for ease of adjustment during listening.
WARNING: Always protect this power wire by installing a fuse or circuit breaker of the appropriate size within 12 inches of the battery terminal connection. 15. FUSE These fuses protect the amplifier against internal electrical damage and are meant to protect the amplifier only. All other power connections should be fused at the source. 16. SPEAKERS: Connect sub woofers to these terminals, SPEAKER CONNECTION MONO Channel System Design #1 INV500DBA © “x WES REN MS Se REE Be © © O=cs ©.
MONO Channel System Design #2 INV1000DBA PH ea 0, 00080 Ge wor weer HERE RE SUE WOOFER bod fe Ca
TROUBLESHOOTING GIDE Issue Possible Cause Solution |s the power LED Check all fuses, replace if necessary. NO SOUND eds Make sure the power is securely fastened.
