Instruction Manual

When connecting the speakers, it is very important to observe the correct polarity. This means
that the wire attached to the (+), red, or positive terminals on one component must be attached
to the (+), red, or positive terminal on the corresponding component speaker output terminals.
Similarly, the (-), Black, Negative or ground terminals must connect to the respective (-), Black,
Negative, or ground terminals. This is easy to do by locating the color stripes that appears on
the included speaker wire. If longer wire run is needed use 16 gauge weatherproof wire up to
50 feet.
1. Insert the weather proof connector from the supplied AC/DC Adaptor to the DC IN Jack on
the Active Speaker. Insert the AC/DC adaptor to a wall outlet having AC 100-240V, 50/60Hz.
2. Push the POWER ON/OFF Switch on the rear of Active Speaker to ON position to turn the
speaker to Standby mode. The LED Indicator on the Active Speaker will light.
3. Select input source
A. If AUX is selected, please connect the Active Speaker to External Audio Device with
supplied AUX-in cable into 3.5mm Jack. Then the speakers will play the music in the
connected Audio Device.
B. If Bluetooth is selected, please activate the Bluetooth of your device and pair the speakers
as below.
a. Turn on your Bluetooth Device, and open the Bluetooth function.
b. Search Bluetooth Device: Ultra Performance.
c. Select device “Ultra Performance” for automatic connection.
d. There will be a notification sound and the LED indicator will turn to red once the pairing is
successful.
e. Play the music and control volume via the paired Bluetooth device
Operations
Connect Right and Left Channel Set
(Red=Positive/Black=Negative)
Notes: When AUX is selected, please disconnect the Bluetooth device firstly, and the LED
indicator should be green.
DO NOT RETURN TO STORE
For Customer Service:
Page 3