Owners manual

1. Set in CD/USB/SD mode & stop the cd/mp3 disc playback.
2. Press the “Program” button, “ PROG “ indicator will appear on LCD display (2). Moreover, it will
indicate program no. and digits for track no. to be programmed.
3. Select a desired track by pressing skip
or buttons (16,17).
4. Press the “ Program ” button to store the trace into memory.
5. Repeat steps 3 and 4 to enter additional tracks into the memory if necessary.
6. When all the desired tracks have been programmed, press CD “ Play/Pause/Stop ”
button (19)
to play the disc in assigned order.
7. To cancel the programmed file, press “Stop” button on remote handset until “ PROG “ indicator is
disappear on LCD display (2)
Playback of MP3 song via USB storage media or memory card
Connecting
The system is able to decode and playback all MP3 file which stored in the memory media with USB
connecting port or SD/MMC memory card.
1. Set Function selector (3) at CD/USB/SD mode and then press source button (7) to select “ USB or
Card” mode.
2. Plug-in the USB plug with the face up & make sure it going into
completely or insert the memory card in the direction of the
arrow as shown in the label on the underside of the memory
card slot cover. Insert straight without bending.
 Connecting the UBS upside down or backwards could
damage the audio system or the storage media (USB
thumb drive / SD/MC card). Check to be sure the direction
is correct before connection.
3. The system will start reading the storage media automatically after connecting, and LCD display (2)
will show the total number of MP3 files and total number of folder being detected.
4. Repeat the same playback procedure as playing cd/mp3 disc as above
Remark
- The system can detect and read the file under MP3 format only though the USB socket or SD/MMC
card.
- If connect the system to MP3 player via the USB socket, due to variances in MP3 encoding
format, some MP3 player may not be able to play via the USB socket. This is not a malfunction
of the system.
- USB port does not support connection with USB extension cable and is not designed for
communication with computer directly.
Listing to tape
General operation
Cassette playback : The system will start the playback automatically after inserting of cassette tape.
Stop and ejection : Press the “ Tape forward / eject “ button completely inwards and the cassette
Tape will be ejected though the cassette door cover. The “ Tape forward/eject“
button will keeping at lowest height position.
Fast forward : Press the “ tape forward / eject “ button half inwards during playback mode, the tape
winding forward direction. The “ Tape forward / eject “ button will keeping at middle
height position.
Slightly press the “ Tape forward / eject “ button again to resume normal playback. The “ Tape forward /
eject “ button will resume to the highest position.
E-4