User Manual

ManualsBrandsPyle Pro ManualsCable Testers & Tone Generators13-in-1 Audio Cable Tester

PCT60 Pro Cable Tester

Congartulations!

The PCT60 accepts a wide range of cable types used in variety of A/V applications

such as XLR (3 and 5-pin), 1/4” and 1/8” TS, TRS, and TT plugs as well as RCA,

MIDI, Speakon (8-P, 4-P), Din 4-P, RJ45, and USB. Choose to either test continuity or

send out test tones. Output level is adjustable between +4dBu pro line level, -10dBV

consumer line level, and -50 mic level. The PCT60 can check for continuity, intermit-

tency, phantom power, and the presence of grounded shields. The unit runs off two

AA 1.5V batteries makinWWg it easy to carry around whether working in the eld or at

home.

www.PyleAudio.com

Summary of content (4 pages)

PAGE 1
PCT60 Pro Cable Tester Congartulations! The PCT60 accepts a wide range of cable types used in variety of A/V applications such as XLR (3 and 5-pin), 1/4” and 1/8” TS, TRS, and TT plugs as well as RCA, MIDI, Speakon (8-P, 4-P), Din 4-P, RJ45, and USB. Choose to either test continuity or send out test tones. Output level is adjustable between +4dBu pro line level, -10dBV consumer line level, and -50 mic level.
PAGE 2
Installing the battery 1. 2. 3. 4. 5. Locate the small screw for the battery cover plate on the back of the unit Using a small Phillips head screwdriver, rotate the small screw counter clockwise. Remove the plate. Insert the two AA batteries with the correct polarity. Reattach battery cover plate, insert screw and turn clockwise to tighten. Testing cables 1. 2. 3. 4. 5. 6. 7. Move the On switch to Cable Tester. To test pins 1-3, you may adjust the Switch 1-3 selector to SW1.
PAGE 3
Intermittent Connections To test for broken connections 1. 2. 3. 4. While in test mode with a cable plugged into both an In and Out, press the reset button to clear the Intermittent LED’s. Next, move the suspected cable end around vigorously while plugged in. If there are any shorted, loose, or broken connections, one of the Intermittent LED’s will light up showing where the break is taking place. Press Reset to clear the LED’s to continue or try again.
PAGE 4
Test Tone Mode 1. 2. 3. 4. To send out a test tone, select Test Tone Mode. Plug the cable into one of the Cable Out’s. Press the Reset button to toggle between a 1kHz and 440Hz tone. You can adjust the signal strength to the appropriate level for testing by adjusting the Test Tone Level selector between -50 (Mic level), -10dBV (Consumer Line Level), and +4dBu (Pro Line Level).