- Pyle DVD Player Operating Instructions

8
9
Mute
Stopplaying EJECT
(available to analog audio output
Signalonly)
Push [MUTE] to silence the sound of the
player, press it again to return to normal
state.
1.Push [EJECT]
2.Push [EJECT] to close thetray
3.Press [POWER] to turn offthe player.
unload the disc until the tray is
ejected. After stopping playing, unload
thedisc until the tray isejected.
Then turn off power of all connected
equipment.
The use of REMOTE SENSOR
If you want to put the DVD player in
where you can not see, please insert
REMOTE SENSOR in the REMOTE
SENSOR INPUT, and put REMOTE
SENSOR on where you can see in
automobile, you can control the DVD
player so long as let REMOTE
CONTROLtoward REMOTE SENSOR.
4. Basic operation
Basic operation
Basic operation
Ifyou have connectedthe product toTV,
all power lines have been plugged into
receptacles, and loaded the batteries
into remote control, so you can play the
player.
Turn on TV power
Play
1.Push [POWER] in the player.
2. Push open/close eject player or [
EJECT] buttons on the remote control
tothe tray.
3.Push [ ] PLAY/PAUSE
If you have connected amplifier, you
should also turn it on, and select proper
amplifier mode according to the type of
discsto be played.
Control TV remote control to shift TV
toproper video input mode (VIDEOIN).
Load a disc in the tray, with label side
upward (see following figure), place
singledisc in the tray,
The player will close the tray
automatically and begin to read it, It can
identify different disc format then
display it on the screen of DVD frontal
panel, afterwards if automatically plays
disc, If directory or menu picture disply
in the screen, you can push the
direction buttons [UP], [DOWN],[LEFT]
and [RIGHT] buttons in the remote
control to move lighting band to desired
track, You can directly push number
buttonsto select track.
While playing push [ ] to pause the
playback, push [ ] again to resume
play
Attention:
Whileplayingif you findthe
picture is not shown in full
screenorsomepart hidden or
black and white image
occur,you need tothesystem,
pleaseselect rightTV system
(PAL or NTSC), Please refer
to instructions of [SYSTEM]
IN CHAPTER 6 or examples
inchapter6.
When the symbol
shows in TV screen, it
signifies invalid operation or
your operation is not
acceptedbytheplayer.
REMOTE
SENSOR